Cement-Bonded Particle Board

Fiber Cement Board

Through Colored Fiber Cement Board

Pergola Awning Shutter Systems and Engines





ENTR

East and West Sub Corparation /     TR
Homepage        Products        Guillotine Glass Engine®

Guillotine Glass Engine®

Description
Properties
Packaging / Storage / Handling

Guillotine Glass Engine®


Tubular Motors work with 220 V electrical energy.

It is especially used where small and medium-sized automatic awnings are required. Frequency of use should not be excessive. Tubular motors are designed to carry loads up to 30 kg. Awning Engine, Pergola Engine, Awning Engine, Wintent Awning Engine, Rolling Roof Pergola Engine, Bioclimatic Pergola Engine, Moving Handrail Engine, Guillotine Glass Engine, Glass Balcony Engine in case of power cuts
 


Advantages of Use


  • Integrated radio receiver
  • Easy Programming
  • Gradual limit switch setting
  • Easy setup

Technical Specifications  


Weight (Kg)

5.0

Flow (A)

2.00

Working Time (min)

>4

Rotation Speed(Rpm)

12

Frequency (Hz)

50

Power (W)

450

Degree of Protection (IP)

IP44

Maximum Number of Rotations (Tour)

32

Torque (N,m)

120

Voltage (V)

230

Areas of Usage


Packaging
Packaging

  • Our panels are transported domestically and internationally with the plate edges painted and the Tepe Betopan® emblem.
  • The panels are on wood pallets covered in plastic with rings and corner brackets added.
  • During transport the panels must be covered in canvas.
  • When the panels are being carried one by one they are recommended to be carried vertically or as close as possible to vertical so as not to be bent.
  • The panels must be stored in a closed area.
  • Whether in storage or at the assembly site the panels must be left in lateral position and should not be leaned either laterally or vertically on a wall or similar surfaces.
  • If the panel packages are to be stacked caution should be taken to align them.
  • If the panels are not going to be used for a long period the packages should be completely covered in plastic to avoid being affected from heat and humidity change (stay stable).
  • After panels are taken from the package to be used the package should be covered over again with the plastic.
  • The storage area must be closed.
  • When stacking pallets the pallet feet should be lined up one on top of the other.
  • Do not take the plastic cover off until use.
  • Do not take off the steel strips until use.
  • The materials should be placed on the smoothest ground possible.
  • When storing, pallets should be carefully placed on top of each other with 5 pallets at most  and the total height of pallets should not exceed 3,5 meters.
  • When loading, only two pallets at a time should be loaded.
  • When loading make sure that the pallets are placed on the truck in a balanced way.
  • Pallets ready for transpor
Packaging